Residential Roofing

How to Compare Roofing Estimates in Tucson

Three roofing bids for one Tucson house can come back far apart and written three different ways. Set them side by side, line by line, from underlayment and decking to payment terms, get every missing line answered in writing, and check the contract against what Arizona law requires before you compare a single price.

Published: October 22, 2026

Last Updated: October 22, 2026

Reviewed By: Jeff Guthrie CEO of Phoenix Roofing & Repair

Three roofers look at the same Tucson house and hand back three bids that are far apart and written three different ways. Before those totals mean anything, each bid has to describe the same job, and until it does, nobody can tell whether the cheap one is a deal or a bid with a line missing. The method below gets every bid describing the same roof before you compare a single price.

📋

What makes two roofing bids comparable?

Matching scope, not matching totals. Two bids can be compared when each one names, in writing, the same roof system and product line, the same underlayment, the same decking terms, the same warranty documents and the same payment schedule. Until every bid states those lines, you cannot tell how much of the gap between the totals is work and how much is price.

Homeowner comparing three roofing estimates on a kitchen table with a handwritten comparison grid

Lay the bids side by side, one line at a time

Start with a single sheet. Put each bid in its own column and give every line below its own row. Copy what each bid says into its cell, word for word. Where a bid says nothing, leave the cell blank. Blanks are the point of the exercise.

It is tempting to read the bottom line first and then hunt for reasons. Do it the other way round and the reasons show up on their own.

Scope, tear-off and disposal

Read what each bid says comes off and what goes back on. A full tear-off down to the deck is a different job from work that leaves the old layers in place, and on a tile roof, lifting the existing tile and relaying it is different again from installing new tile. Check which parts of the house are included: the main roof, the garage, a patio cover, a flat section out back. Then find the line that says who hauls the old roofing away. If a bid does not mention disposal, ask.

The roof system, named down to the product

"Tile roof" and "30-year shingle" are categories, not products. A bid you can compare names the manufacturer and the product line for the roofing itself and for the underlayment beneath it. Two bids that both say "underlayment" can be quoting very different materials, and you cannot hold a roofer to a product the paper never named. Ask which manufacturer warranty the installer will register on that product, and get its name in writing.

Underlayment, flashing and edges

Underlayment is the layer between the deck and the roofing you see. Look for its type and how many layers each bid includes, because a bid with one layer and a bid with two are not the same scope.

Flashing is the metal at walls, chimneys, skylights and valleys, where leaks commonly start. The line to look for is whether it gets replaced or reused. Reusing old flashing is cheaper today, which can be one reason a bid comes in lower. The same goes for the drip edge at the roof's perimeter, pipe boots and roof vents: each should say new, reused or not included.

Decking: included, per sheet, or a credit

Decking is the plywood or board under everything else, and nobody knows its condition until the old roof is off. That is why this is the line where a low total moves. Bids handle it in one of three ways:

❓

"Replace decking as needed"

Open-ended. It sets no price and no limit, so the final bill is unknown until the roof is open.
📐

A per-sheet price

Each sheet of rotten decking replaced costs a stated amount. The rate is known; the count is not, so the total still depends on what the crew finds.
✅

A credit or allowance already in the price

A set amount of decking replacement is built in, and only damage beyond it costs extra.

Two bids with matching totals are not the same price if one includes a credit and the other says "as needed". Ask each bidder to state its decking terms the same way, and to say how you will see rotten decking before you pay for it. Our own Tucson estimates include a wood credit to help cover unforeseen decking where it applies. Hold every bid on your sheet to the same test, ours included: a decking line you can turn into a number.

Warranty, cleanup and payment terms

A roof usually comes with two warranties from two different companies. The manufacturer covers defects in the material. The roofer covers the installation. Put each bid's material warranty in one row and its workmanship warranty in another, and ask for both documents rather than a number of years on the front page.

Cleanup belongs on the sheet too. A bid can list covering landscaping and pools, removing tarps and debris, and running a magnet over the yard for nails, or it can say nothing. The bid that says nothing has not promised it.

Last, payment. Note the deposit, each progress payment and the stage of the job that triggers it, and the final payment. If a bid gives a total and no schedule, that row stays blank until the roofer fills it in.

Why Tucson bids for one roof land so far apart

A Tucson house can carry a pitched tile roof and a flat foam section on the same building, and each roofing system hides different things inside a single total. Knowing which line to look at on each one tells you where to start asking.

Tile roofs: the bid is mostly about what sits under the tile

On a tile roof the tile is only part of the system. The tile industry's installation manual for moderate climates, from TRI and the Western States Roofing Contractors Association, sets minimum recommendations with optional upgrades for the underlayment, flashing and fastening under the tile. It specifies underlayment by roof slope: on slopes between 3:12 and 4:12, for instance, its options include a self-adhering membrane or two layers of felt. So two tile bids can both be honest and still be far apart: one prices the minimum, the other an upgrade.

The other tile line is the tile itself. A bid that relays your existing tile should say how broken pieces get replaced and whether the replacements match your tile's profile. A bid for new tile has no such question, and costs more for a reason you can see.

Foam roofs: the coating line decides the comparison

Spray foam is protected from the sun by its coating. ASTM International's standard guide for sampling foam roofs puts it directly: adequate coating thickness, measured in mils, is necessary to protect the foam from ultraviolet degradation. A foam bid that names the coating but not its thickness, or the foam's thickness, gives you nothing to compare against. Ask every foam bidder for the foam thickness, the coating product, the coating thickness and the number of coats.

Shingle roofs and the heat

Shingle bids look the easiest to compare and often are not. In Arizona's climate a shingle's usable life is often shorter than the rating on its label, so the years printed on the package are the weakest line to compare on. What separates two shingle bids is the product line and the warranty attached to it. A bid that names only a shingle "grade" leaves the most important row empty.

Concrete roof tiles lifted and stacked on a tile roof, showing the underlayment and wooden battens underneath

How do you put the bids on equal footing before comparing price?

Close the blanks in writing before you look at a single total. Phone answers drift, and the roofer who tells you on the phone that flashing is included has not changed the bid you will sign.

Checking each bidder's license, insurance and track record is a separate job, and our guide on how to vet a roofing contractor in Arizona covers it. Comparing the bids themselves comes down to two steps.

Send every bidder the same questions

Go back to your sheet. Every blank cell and every vague phrase ("as needed", "standard underlayment", "as required") becomes a question. Use the most complete bid as your list of rows, then send each roofer the questions for their own blanks, in writing, and ask for a revised bid rather than a reply. When the revised bids come back, every column should have an answer in every row.

Now compare totals. Whatever difference is left is a price difference for the same described job, and that is a number you can actually weigh. If you want a sense of what a full replacement usually runs before you get there, our breakdown of what a roof replacement costs covers the ranges and what moves them.

When the low bid is low because a line is missing

A low bid is not a red flag by itself. Some roofers run leaner, and some price an upgrade as optional that another builds in. It becomes a warning only when the gap traces back to a row: no decking terms, reused flashing, one layer of underlayment where the others quote two, no coating thickness on a foam roof. Those are the lines where the price can still change after you sign. If the low bidder fills them in and stays low, you have learned something useful. If the number climbs, you have learned something more useful.

What the contract has to say before you sign

The bid you choose becomes a contract, and Arizona already sets out much of what that contract must contain. Use the law as the floor and your comparison sheet as everything above it.

What Arizona law requires in writing

Under A.R.S. 32-1158, any contract over $1,000 between a contractor and a property owner has to state in writing:

  • the contractor's name, business address and license number
  • your name and mailing address and the job's address
  • the date you both entered into the contract
  • the estimated date the work will be finished
  • a description of the work
  • the total price, including all applicable taxes
  • any advance deposit
  • each progress payment and the stage of construction at which it is due
  • your right to file a written complaint with the Arizona Registrar of Contractors, with the Registrar's phone number and website, printed in bold type

When you sign, the contractor has to give you a legible copy of everything you signed, and a receipt for any cash you pay. The license number matters before you get that far: Arizona law makes it unlawful to submit a bid without a contractor's license in good standing (A.R.S. 32-1151), so every bid you are comparing should already show one. Ours is ROC #340941.

What to add that the law does not require

The statute asks for "a description of the work". It does not say how detailed. Your sheet is how detailed. Before signing, check that the contract carries the same rows as the revised bid: the named products and underlayment, the flashing work, the decking terms, the cleanup, and the warranty documents themselves.

Two more lines belong in it. One is who pulls the permit, since the City of Tucson and Pima County run separate permit offices; our guide to the Tucson re-roof permit explains which one covers your address. The other is how changes get approved: in writing, by you, before the extra work starts.

How many bids are worth getting

Enough that the scope can disagree. Two bids for the same roof system will show you where one roofer saw something the other missed; a third helps when the first two disagree on something big, like whether the decking needs work. At least one of them should follow a real inspection of the roof, because a bid written from the driveway is a guess at the scope, and a guess cannot be compared line for line. If you would like one of your bids from our Tucson office, the inspection and the written estimate are free.

Bidding a commercial building is a different exercise, with engineering, phasing and bonding in the scope. Our guide to commercial roof replacement is the place to start for that.

Questions Tucson homeowners ask about roofing bids

Roofers measure in squares, and one square is 100 square feet of roof surface. If two bids give different square counts for the same house, ask each roofer whether the number is the measured roof or the material ordered including waste for cuts, because a bid can quote either.

Arizona's written requirements in A.R.S. 32-1158 apply to the contract, not to the estimate: any contract over $1,000 has to put the work description, the total price and the payment schedule, among other items, in writing. Ask for every bid in writing anyway, so you can check the contract against it line by line before you sign.

Compare the products and their warranties, not the logos. Ask each roofer for the manufacturer's product sheet and the name of the warranty they will register, then set what each warranty covers, and for how long, side by side.

The work should stop long enough for the damage to be documented and priced, and for you to approve it. Phoenix Roofing & Repair handles hidden damage such as wet insulation or rotten decking past the wood credit that way, and nothing extra goes ahead until the homeowner signs off. Ask every bidder to put the same promise in the contract.

Only if you can keep the warranty in force. Our residential workmanship warranty, for example, covers labor only, sits behind the manufacturer's material warranty, needs a documented professional inspection once a year, and transfers once with written notice within 30 days of a sale. Ask each bidder for the same conditions before a longer term earns any weight.

Share the scope, not the price. Give every bidder the same written list of what you want priced, built from the most complete bid, and leave the other numbers out, so the bids line up without turning into an auction.

Sources and References

  1. Arizona Revised Statutes 32-1158, contract requirements; provision of documents and receipt at contract signing. Arizona State Legislature. azleg.gov. Accessed October 2026
  2. Arizona Revised Statutes 32-1151, engaging in contracting without a license prohibited. Arizona State Legislature. azleg.gov. Accessed October 2026
  3. TRI and Western States Roofing Contractors Association, Concrete and Clay Roof Tile Installation Manual for Moderate Climate Regions (2010). PDF. Accessed October 2026
  4. ASTM International, D7119/D7119M-21, Standard Guide for Sampling Spray Polyurethane Foam and Coating in Roofing. astm.org. Accessed October 2026

Want a written estimate based on an inspection of your roof?

Call the Tucson office at (520) 917-9152 and we will schedule an inspection, on the roof itself wherever that is possible, then hand you a written estimate you can put straight onto your comparison sheet. If you would rather start online, request a free roof inspection through the estimate form.
Serving the Tucson metro.

Share

Arizona Roofing Done Right

Reliable, long-lasting roofing solutions designed for your home, your peace of mind, and your future.

Related Blogs

Commercial Roofing

November 6, 2026

How to Prepare Tenants for a Roof Replacement in Tucson

A guide for Tucson property managers on telling tenants about a re-roof: when the first notice goes out, what it should say, how rooftop HVAC shutdowns, odor, parking and closed zones are handled, and who tenants call while the crew is working overhead….

Commercial Roofing

November 4, 2026

Commercial Roof Drainage Systems: How They Work and What to Check Before Tucson’s Monsoon

Before the monsoon reaches Tucson, every drain, scupper, gutter and overflow on a flat commercial roof should be cleared, tested and checked at its seal. How each one carries water off the roof, what failure looks like after dust storms and heat, when to have the drains checked, and what to record for each one….

Costs, Insurance & Financing

November 3, 2026

Should You File a Claim for Roof Damage in Tucson, or Pay for the Repair?

A Tucson storm left damage on the roof, and now the question is money: file a claim or pay for the repair yourself. Here is how to decide with your deductible, your claim history and a written estimate, and what Arizona law says about asking your insurer, renewals and the deductible….